Adding the new node to the vxfen service group

Last published : Sep 11, 2026
Perform the steps in the following procedure to add the new node to the vxfen service group.
To add the new node to the vxfen group using the CLI
  1. On one of the nodes in the existing VCS cluster, set the cluster configuration to read-write mode:
    \# haconf -makerw
    1. Add the node sys5 to the existing vxfen group.
    \# hagrp -modify vxfen SystemList -add sys5 2
  2. Save the configuration by running the following command from any node in the VCS cluster:
\# haconf -dump -makero