Configuring the ClusterService group for the new node

Last published : Jun 10, 2026
If the ClusterService group is configured on the existing cluster, add the node to the group by performing the steps in the following procedure on one of the nodes in the existing cluster.
To configure the ClusterService group for the new node
  1. On an existing node, for example sys1, write-enable the configuration:
    \# haconf -makerw
    1. Add the node Sys5 to the existing ClusterService group.
    \# hagrp -modify ClusterService SystemList -add Sys5 2
\# hagrp -modify ClusterService AutoStartList -add Sys5
  1. Modify the IP address and NIC resource in the existing group for the new node.
    \# hares -modify gcoip Device en0 -sys Sys5\# hares -modify gconic Device en0 -sys Sys5
  2. Save the configuration by running the following command from any node.
\# haconf -dump -makero