Upgrading Storage Foundation and High Availability with the product installer

Last published : Sep 28, 2026
This section describes upgrading to the current Storage Foundation and High Availability, and you do not intend to upgrade your Solaris version. Only use this procedure if you are already running a version of Solaris that is supported with 8.0.
To upgrade Storage Foundation and High Availability
  1. Log in as superuser.
  2. Unmount any mounted VxFS file systems.
The installer supports the upgrade of multiple hosts, if each host is running the same version of VxVM and VxFS. Hosts must be upgraded separately if they are running different versions.
If any VxFS file systems are mounted with the QuickLog feature, QuickLog must be disabled before you upgrade. See the "Veritas QuickLog" chapter of the Veritas File System Administrator's Guide for more information.
  1. If you upgrade a high availability (HA) product, take all service groups offline.
List all service groups:
\# /opt/VRTSvcs/bin/hagrp -list
For each service group listed, take it offline:
\# /opt/VRTSvcs/bin/hagrp -offline service_group \
  -sys system_name
  1. Enter the following commands on each node to freeze HA service group operations:
    \# haconf -makerw
    \# hasys -freeze -persistent nodename
    \# haconf -dump -makero
    1. If your system has separate /opt and /var file systems, make sure that they are mounted before proceeding with installation.
    2. If replication using VVR is configured, verify that all the Primary RLINKs are up-to-date:
    \# vxrlink -g diskgroup status rlink_name
Note: Do not continue until the Primary RLINKs are up-to-date.
  1. Load and mount the disc.
  2. To invoke the common installer, run the installer command on the disc as shown in this example:
    \# cd /cdrom/cdrom0
    \# ./installer
    1. Enter G to upgrade and press Enter.
    2. You are prompted to enter the system names (in the following example, "host1"). Enter the system name or names and then press Return.
    Enter the system names separated by spaces on which to
    install SFHA:  host1
Depending on your existing configuration, various messages and prompts may appear. Answer the prompts appropriately.
  1. Installer asks if you agree with the terms of the End User License Agreement. Press y to agree and continue.
  2. The installer then prompts you to name the backup boot disk group. Enter the name for it or press Enter to accept the default.
    Note: The split operation can take some time to complete.
  3. You are prompted to start the split operation. Press y to continue.
  4. Stop the product's processes.
Do you want to stop SFHA processes now? ? [y,n,q] (y) y
  1. The installer lists the packages to install or upgrade, and performs the installation or upgrade.
  2. The installer verifies, configures, and starts the Storage Foundation software.
  3. Only perform this step if you have split the boot disk group into a backup disk group. After a successful restart, verify the upgrade and re-join the backup disk group. If the upgrade fails, revert to the backup disk group.