Preparing the CP servers manually for use by the SFHA cluster
Use this procedure to manually prepare the CP server for use by the SFHA cluster or clusters.
Table: Sample values in procedure displays the sample values used in this procedure.
Related information
Table: Sample values in procedure
| CP server configuration component | Sample name |
|---|---|
| CP server | cps1 |
| Node #1 - SFHA cluster | sys1 |
| Node #2 - SFHA cluster | sys2 |
| Cluster name | clus1 |
| Cluster UUID | {f0735332-1dd1-11b2} |
To manually configure CP servers for use by the SFHA cluster
-
Determine the cluster name and uuid on the SFHA cluster.
For example, issue the following commands on one of the SFHA cluster nodes (sys1):
\# grep cluster /etc/VRTSvcs/conf/config/main.cfcluster clus1\# cat /etc/vx/.uuids/clusuuid{f0735332-1dd1-11b2-bb31-00306eea460a}
-
Use the
cpsadmcommand to check whether the SFHA cluster and nodes are present in the CP server.
For example:
\# cpsadm -s cps1.example.com -a list_nodes
ClusName UUID Hostname(Node ID) Registered
clus1 {f0735332-1dd1-11b2-bb31-00306eea460a} sys1(0) 0
clus1 {f0735332-1dd1-11b2-bb31-00306eea460a} sys2(1) 0
If the output does not show the cluster and nodes, then add them as described in the next step.
For detailed information about the
cpsadm command, see the InfoScale Cluster Server Administrator's Guide.
-
Add the SFHA cluster and nodes to each CP server.
For example, issue the following command on the CP server (cps1.example.com) to add the cluster:
\# cpsadm -s cps1.example.com -a add_clus\
-c clus1 -u {f0735332-1dd1-11b2}Cluster clus1 added successfully
Issue the following command on the CP server (cps1.example.com) to add the first node:
\# cpsadm -s cps1.example.com -a add_node\
-c clus1 -u {f0735332-1dd1-11b2} -h sys1 -n0Node 0 (sys1) successfully added
Issue the following command on the CP server (cps1.example.com) to add the second node:
\# cpsadm -s cps1.example.com -a add_node\
-c clus1 -u {f0735332-1dd1-11b2} -h sys2 -n1Node 1 (sys2) successfully added
More Information