Starting the software configuration
You can configure VCS using the product installer.
Note: If you want to reconfigure VCS, before you start the installer you must stop all the resources that are under VCS control using thehastopcommand or thehagrp -offlinecommand.
To configure VCS using the product installer
-
Confirm that you are logged in as a superuser.
-
Start the configuration using the installer.
\# /opt/VRTS/install/installer -configure
The installer starts the product installation program with a copyright message and specifies the directory where the logs are created.
-
Select the component to configure.
-
Continue with the configuration procedure by responding to the installer questions.
Related information