About the Campus Cluster solution
This chapter presents a VCS campus clustering configuration example with InfoScale Enterprise.
The following table outlines the configuration's high-level objectives and the tasks for each objective.
Related information
Table: Task list: Campus Cluster configuration
| Objectives | Tasks |
|---|---|
| See Reviewing the configuration . | - Review the configuration requirements |
| - Overview of VCS campus cluster, and recovery scenarios | |
| See Installing and configuring the hardware . | - Install the hardware for Site A |
| - Install the hardware in the same manner for Site B | |
| - Make all the necessary hardware connections between the two cluster nodes | |
| See Configuring the storage hardware and network . | - Install the operating system on both nodes |
| - Make necessary networking settings on both nodes | |
| See About installing the Veritas InfoScale products . | Install InfoScale Enterprise. Refer to the Veritas InfoScale Installation and Upgrade Guide . |
| See Configuring the cluster using the Cluster Configuration Wizard . | Use the VCS Cluster Configuration Wizard (VCW) to set up the cluster |
| See Creating disk groups and volumes . | - Create dynamic cluster disk groups |
| - Create dynamic volumes | |
| See Installing the application on cluster nodes . | - Install the application program files on the local drive of the first node |
| - Install files relating to the data and logs on the shared storage | |
| - Deport the disk groups on the first node and import them on the second node | |
| - Install the application on the second node | |
| See Configuring service groups . | - Use an appropriate method to create and configure the VCS service group or groups |
| - Bring the service group online | |
| See Verifying the cluster configuration . | - Switch the service group to the second node |
| - Switch it back to the first node |