Starting LLT, GAB, and VCS after manual configuration

Last published : Sep 11, 2026
After you have configured LLT, GAB, and VCS, use the following procedures to start LLT, GAB, and VCS.
To start LLT
  1. On each node, run the following command to start LLT:
    \# /etc/init.d/llt.rc start
    If LLT is configured correctly on each node, the console output resembles:
    Loading LLT Driver...
    Starting LLT:
    LLT: loading module...
    Loaded   kernel_version on kernel kernel_version
    LLT: configuring module
    where, kernel_version is the kernel version
    of the Linux operating system
  2. On each node, run the following command to verify that LLT is running:
    \# /sbin/lltconfig
    LLT is running
    To start GAB
    1. On each node, run the following command to start GAB:
    \# /etc/init.d/gab.rc start
If GAB is configured correctly on each node, the console output resembles:
GAB: Starting
GAB: Starting Done
  1. On each node, run the following command to verify that GAB is running:
    \# /sbin/gabconfig -a
    GAB Port Memberships
    ===================================
    Port a gen a36e0003 membership 01
    To start VCS
    • On each node, type:
    \# /etc/init.d/vcs.rc start
Related information