Verifying server-based I/O fencing configuration

Last published : Jun 11, 2026
Follow the procedure described below to verify your server-based I/O fencing configuration.
To verify the server-based I/O fencing configuration
  1. Verify that the I/O fencing configuration was successful by running the vxfenadm command. For example, run the following command:
    \# vxfenadm -d
    Note: For troubleshooting any server-based I/O fencing configuration issues, refer to theCluster Server Administrator's Guide.
    1. Verify that I/O fencing is using the specified coordination points by running the vxfenconfig command. For example, run the following command:
    \# vxfenconfig -l
If the output displays single_cp=1, it indicates that the application cluster uses a CP server as the single coordination point for server-based fencing.