About the upgrade
This release supports upgrades from 6.1 and later versions. If your existing installation is from a pre-6.1 version, you must first upgrade to version 6.1, then follow the procedures mentioned in this document to upgrade the product.
The installer supports the following types of upgrade:
-
Full upgrade
-
Automated upgrade using response files
-
Phased Upgrade
-
Rolling Upgrade
Table: Veritas InfoScale product mapping after upgrade describes the product mapping after an upgrade.
Related information
Table: Veritas InfoScale product mapping after upgrade
| Product (6.2.x and earlier) | Product (7.0 and later) | Component (7.0 and later) |
|---|---|---|
| SFHA | Veritas InfoScale Enterprise | SFHA |
Note: From 7.0 onwards, the existing Veritas InfoScale product upgrades to the higher version of the same product. For example, Veritas InfoScale Enterprise 7.1 gets upgraded to Veritas InfoScale Enterprise 7.2.
During the upgrade, the installation program performs the following tasks:
-
Stops the product before starting the upgrade
-
Upgrades the installed packages and installs additional packages
If your current installation uses a permanent license key, you will be prompted to update the license to 7.3.1. If you choose not to update, you can continue to use the old license, limiting the capability of your product to the corresponding component. For example, if you choose not to update the permanent license of your existing SFHA installation, the installer after upgrade will enable SFHA component. The capabilities of other components in the product Veritas InfoScale Enterprise will not be available to you. If your installation uses a keyless license, the installer registers the new keys for the new product with full product capabilities.
-
Restores the existing configuration.
For example, if your setup contains an SFHA installation, the installer upgrades and restores the configuration to SFHA. If your setup included multiple components, the installer upgrades and restores the configuration of the components.
-
Starts the configured components.