Pre-upgrade planning when VVR is configured
Before installing or upgrading Volume Replicator (VVR):
-
Confirm that your system has enough free disk space to install VVR.
-
Make sure you have root permissions. You must have root permissions to perform the install and upgrade procedures.
-
If replication using VVR is configured, Veritas recommends that the disk group version is at least 110 prior to upgrading.
You can check the Disk Group version using the following command:
\# vxdg list diskgroup
-
If replication using VVR is configured, make sure the size of the SRL volume is greater than 110 MB.
Refer to the Veritas InfoScale® Replication Administrator's Guide.
-
If replication using VVR is configured, verify that all the Primary RLINKs are up-to-date on all the hosts.
\# /usr/sbin/vxrlink -g diskgroup status rlink_name
Note: Do not continue until the primary RLINKs are up-to-date.
-
If VCS is used to manage VVR replication, follow the preparation steps to upgrade VVR and VCS agents.
See the Veritas InfoScale® Replication Administrator's Guide for more information.
See the Getting Started Guide for more information on the documentation.
Related information