Modifying the service group configuration

Last published : Jun 10, 2026
Perform the following procedure to modify a service group's configuration.
To modify the configuration to manage a zone
  1. Run the hazonesetup script to set up the zone configuration.
\# hazonesetup [-t] -g sg_name -r res_name -z zone_name\
[-u user_name] -p password [-a] [-l] -s systems
Where the values are:
-t Updates the password for the VCS zone user.
-g sg_name Name of the zone service group to be created in VCS configuration.
-r res_name Name of the zone resource to be created in VCS configuration.
-z zone_name Name of the zone that is configured on the system.
-u user_name Name of the VCS user used for password less communication between the local zone and the global zone.
If no username is specified the default username is used.
-p password Password for the VCS user used for password less communication.
If Veritas Authentication Service is enabled, the password should be at least six
characters long.
-a Populate AutoStartList for the group.
-l Configure a parallel service group. If you do not specify the -l option, a failover service group is created by default.
-s systems A comma separated list of systems where the zone service group need to be configured, for example: sys1,sys2,sys3.
If the service group does not exist, the script creates a service group.
The script adds a resource of type Zone to the service group. The script logs in to the zone and runs the halogin command. It also creates a user account with group administrative privileges to enable password less communication between global zone and local zone for VCS.
  1. Modify the resource dependencies to reflect your zone configuration. See the resource dependency diagrams for more information.
  1. Save the service group configuration and bring the service group online.
Related information