Requirements for discovering logical partitions

Last published : Jun 19, 2026
Logical partition (LPAR) virtualization discovery pre-requisites are as follows:
For basic LPAR discovery you need to:
  • Add Hardware Management Console (HMC) to Veritas InfoScale Operations Manager domain by control host.
  • Configure the required storage arrays (providing storage to the LPAR servers) using the Storage Insight Add-on. This is required to discover the correlation of storage inside the VIO server with the storage arrays.
  • For VIO servers with Veritas dynamic multi-pathing installed: Install the VRTSsfmhpackage on the VIO servers and configure them in Veritas InfoScale Operations Manager as agents.
  • You must have at least hmcoperator role in HMC to perform these tasks.
    Note: The Veritas InfoScale Operations Manager supports only legitimate filename characters in an LPAR profile name. The special characters reserved for Operating System usage (for example space, "\", "$", "!", "&") are not supported. It is recommended to use upper and lower case alphabets, numeric values (0-9), "_" and "-" for the LPAR profile name.
For storage correlation discovery, in addition to the above mentioned pre-requisites, ensure that:
  • You configure LPAR guests with VRTSsfmh package. It provides the discovery of correlation of storage inside LPAR guests with that exported from the VIO servers.
More Information
About the virtualization technologies supported