Configuring Veritas InfoScale Operations Manager on Linux and Windows

Last published : Aug 24, 2026
After you successfully install Management Server, a message is displayed with the URL that you can use to configure Veritas InfoScale Operations Manager. On Windows, if you chose to launch the configuration, the Web browser is automatically launched with the URL.
For Internet Explorer 7.0, or later, on Windows Server 2008, or Firefox 3.0, or later, if the webpage does not get displayed, you have to set up the Web browser.
Note: You may configure the networking on Management Server in either the IPv4 mode, or in the mixed mode (IPv4 and IPv6). For Management Server that runs in the mixed mode, use only the IPv4 address during the installation and configuration process and not the IPv6 address. For Management Server configuration with IPv6 address, the localhost, 127.0.0.1, ::1 should be bound to a network interface that is up and running. For example, lo0 on Linux.
To configure Veritas InfoScale Operations Manager on Linux and Windows
  1. Launch the Web browser. On Windows, if you chose to launch the configuration after installation, the Web browser is automatically launched.
    • On a host that has a network connection to the Management Server host, open a Web browser.
    • Launch the following URL:
https://*hostname* :5634/
Where, hostname is the Management Server's host name or fully-qualified host name. For a IPv4 configuration, you can alternatively specify the IP address instead of the host name.
For the dual-mode configuration of Management Server, the IPv6 address and the host name entries of the managed hosts should be present in the /etc/hosts file on Management Server. Also, all the managed hosts should have an entry of the IPv6 address and the host name of Management Server in their respective /etc/hosts file.
  1. In the Authentication Required dialog, enter Management Server host's root or administrator user name and password.
  2. In the Server Setting panel, check and modify the Server Name , if required.
  3. Check and modify the Server Address , if required.
  4. In the Database Setting panel, you can accept the default location or specify your own location. To modify the default location, clear Use Default and specify another location. On Windows, if you modify the default, you must have Full control permission on the drive that you specify.
The default database directory is /var/opt/VRTSsfmcs/db on Linux and %ALLUSERSPROFILE%\Symantec\VRTSsfmcs\db on Windows.
  1. Click Next.
  2. In the Analytics Setting panel, select Enable Analytics Gathering to allow Symantec to gather data on your Veritas InfoScale Operations Manager usage.
  3. Do one of the following:
    • To change settings, click Back ,
    • To start the configuration, click Finish.
At the end of the Veritas InfoScale Operations Manager configuration, messages similar to the following are displayed:
Configuration successful.
Click the Launch Web Console button to login.
  1. Click Launch Web Console to log on to Veritas InfoScale Operations Manager on the configured Management Server host.
More Information
Installing Management Server on Linux
Installing Management Server on Windows