Re-enabling the DMP paths
You can re-enable the DMP paths for the initiator, enclosure, or the virtualization server that you have disabled as a part of the maintenance operation. You can re-enable the DMP paths in the following ways:
-
Immediately after disabling the DMP paths. Use the same wizard panel to re-enable the disabled paths.
-
Using the Resume Case and Re-Enable Paths options for the DMP case under the Waiting Cases section on the Solution section. For initiator, use Solution section under the Server perspective, for enclosure, use Solution section in the Storage perspective, and for virtualization server, use Solution section in the Virtualization perspective.
To re-enable the DMP paths immediately after disabling them
-
After you disable the DMP paths on an array, initiator, or a virtualization server, click Next.
-
In the Paths Re-Enable Confirmation panel, click Re-Enable.
-
In the Path Enable Operation Output Summary panel, review the details of the re-enabled DMP paths.
-
In the DMP Maintenance Result Summary page, view the details of the current paths and the commands run to complete the operation. Click Close.
To re-enable the DMP paths using the Solutions page
-
In the Management Server console, do the following:
-
For enclosure, go to the Solutions page of the Storage perspective.
-
For initiator, go to the Solutions page of the Server perspective.
-
For virtualization server, go to the Solutions page of the Virtualization perspective.
-
-
Under the Waiting Cases section, select the required case. Right-click and then select Resume Case and Re-Enable Paths.
-
In the Paths Re-Enable Confirmation panel, click Re-Enable.
-
In the Path Enable Operation Output Summary panel, review the details of the re-enabled DMP paths.
-
In the DMP Maintenance Result Summary page, view the details of the current paths and the commands run to complete the operation. Click Close.
More Information